SKF three piece drawing piece

SKF three piece drawing piece can remove the bearing correctly and effectively
TMMS series of three piece strong drawing pieces is specially designed for matching with three arm puller. Grab the rear side of the bearing inner ring with a strong pulling piece. It can avoid the transfer of drawing force to the bearing outer ring and rolling element, so as to minimize the risk of damage to the bearing. The TMMS series includes five different sizes and specifications of three piece strong drawing plates, which are suitable for bearings with diameters of 50 to 380 mm (2 to 15 in).
The unique design of TMMS series drawing sheet enables it to apply the disassembly force to the effective point, that is, the inner ring, so the disassembly force required is smaller than grasping the outer ring.
The powerful drawing piece firmly grasps the rear side of the bearing inner ring to ensure that the drawing force is only transmitted through the inner ring, not through the outer ring or rolling element, so as to avoid damaging the bearing.
The three piece structure makes the pulling force evenly distributed to avoid bearing deflection and jamming on the shaft during disassembly. It is especially suitable for spherical roller bearing and carb ® Disassembly of bearing.
It can be used with other types of three arm pullers
The special wedge-shaped design allows the drawing piece to be easily inserted between the bearing and the shaft shoulder
A wide range of models are available to meet most common sizes of bearings